When using the automatic binding machine to bind the double coil or the nylon covered plastic line, it can effectively improve the working efficiency and reduce the working cost. Then, what are the things to pay attention to when using it?
Binding is limited to paper. Before the drilling, carefully check the bound paper to remove the debris that is easily damaged by pins, clips, staples, magnetic cards, tapes, etc., which will be damaged in the paper. Otherwise, it will be forbidden to touch the drill with your hand when working. Place your hand under the drill or platen.
When loading and unloading the drill, the power switch should be turned off to avoid operator injury. When drilling, the temperature of the drill is very high. Do not touch the surface with your hands to avoid burns. If you need to replace the drill, you must wait for the drill to cool before disassembling. When the drill does not drill through the paper and returns automatically, ask the operator to remove the drill chip, grind the drill or replace the drill.
Avoid punching holes in the drilled or stapled position as this will cause chipping. The spacing of the binding holes should not be too small, otherwise it will affect the hot stamping of the binding tube.
The above aspects are things to be aware of when using the binding machine. I hope to help you.