Home > News > Content
Punching And Binding Equipment Instructions
May 16, 2017

Punching and Binding Equipment The use of the binding machine is to help us in the future to use more convenient, but also for future maintenance and maintenance will not be a problem, to extend the service life.

The general hot riveting machine can be divided into two steps in the following steps. The general binding machine has a ruler can be used as a benchmark to adjust the left and right position, behind the board can adjust the front and back margins, the general adjustable margin is 2.5CM or so, the manual machine can be rotated by the machine behind the knob to adjust the automatic machine through Side of the two knobs to adjust, after a good position can punch. After the hole in general rivets will automatically cut, fall in the takeover slot. Just put the cut rivets into the hole, in the translation to the left rivet head, the mandrel into the riveting tube and then press the handle, press only stay 2-3 seconds. Manual binding machine mandrel must be with the above silver knob no gap can be. What do you need to pay attention to during the punching process?

Binder Punch Note:

A, before punching to remove the pin, staples and other metal objects.

B, before binding, please make sure the glue has been dry, the glue is not dry under the binding will affect the drill life.

C, the use of unskilled circumstances try not to hole in the original hole, binding to set aside a certain margin, do not be too close. D, the use of manual binding machine to pay attention to the length of the knife.

Punching and Binding Equipment In addition to automatic binding machine, the general binding machine can be divided into two steps to the final binding.

The first step is to punch. The general binding machine has a ruler can be used as a benchmark to adjust the left and right position, behind the board can adjust the front and back margins, the general adjustable margin is 2.5CM or so, the manual machine can be rotated by the machine behind the knob to adjust the automatic machine through Side of the two knobs to adjust, after a good position can punch.

Punching and Binding Equipment Precautions:

A, before punching to remove the pin, staples and other metal objects.

B, before binding, please make sure the glue has been dry, the glue is not dry under the binding will affect the drill life.

C, the use of unskilled circumstances try not to hole in the original hole, binding to set aside a certain margin, do not be too close.

D, the use of manual binding machine to pay attention to the length of the knife.

The second step is manual heat riveting binding. After the hole in general rivets will automatically cut, fall in the takeover slot. Just put the cut rivets into the hole, in the translation to the left rivet head, the mandrel into the riveting tube and then press the handle, press only stay 2-3 seconds